Tan Brown
A warm tan brown, deeper than natural oak. In herringbone it gives an earthy, inviting floor with a tidy Prime face.
- 15mm thick
- 3mm top layer
- 120mm wide
- Grade Prime
- Matt UV lacquer, gloss 5-8%
This floor will be added to your booking.
Visit a showroom
- Brookvale3/764 Pittwater Rd, Brookvale NSW 2100Open today until 5pm1800 577 313sales@flooringzone.com.auDirections
- Leichhardt577 Parramatta Rd, Leichhardt NSW 2040Open today until 5pm1800 577 313sales@flooringzone.com.auDirections
- Bondi Junction1/64 Bronte Rd, Bondi Junction NSW 2022Coming soon1800 577 313bondi@flooringzone.com.auDirections
Call ahead and we’ll confirm which showroom has it on display.
Will it suit your home?
Straight answers, from the manufacturer’s own documents.
- Bathrooms & laundriesNot suitable
Not for bathrooms, toilets, laundries or any room with a floor drain; the warranty excludes them.
- Underfloor heatingWith conditions
Hydronic heating only, with the floor surface never above 26°C; electric heating isn't suitable.
- Sanding & refinishingVoids the warranty
Sanding or refinishing the factory finish voids the warranty, so look after the surface with felt pads and mats.
- Pets & high trafficWith care
Brushed matt lacquer hides light marks, but damage from grit, dragged furniture, stilettos and dropped items isn't covered by warranty.
- Apartments (acoustic)Rating not confirmed
No acoustic test results are published for this format, so check with us and your strata before choosing it for an apartment.
Conditions apply; we’ll confirm for your room at the measure.
About this floor
A warm tan brown, deeper than natural oak. In herringbone it gives an earthy, inviting floor with a tidy Prime face.
This oak herringbone uses Prime-grade European oak, the cleanest of three grades, so the pattern reads clearly without busy knots. Each block is 600mm long, 120mm wide and 15mm thick, with a 3mm oak top layer on cross plywood, tongue-and-groove edges and a four-sided micro bevel. The brushed face carries a super-matt UV lacquer. There are 15 colours, from white-washed through natural to charred. Herringbone must be glued directly to the subfloor; it can't float. Allow about 20% extra for cutting waste, and use an installer experienced in parquetry. It suits living rooms, entries and dining rooms. Keep it out of bathrooms, laundries and rooms with a floor drain. Hydronic underfloor heating is allowed with the floor kept at 26°C or below; electric heating isn't. Refinishing voids the warranty. The warranty covers wear for 20 years in homes and the board structure for life, subject to the manufacturer's installation and care conditions.
Full specifications
Dimensions
| Thickness | 15mm |
|---|---|
| Width | 120mm |
| Length | 600mm |
| Pack size | 1.152 m² |
| Boards per pack | 16 |
Construction
| Species | European Oak |
|---|---|
| Construction | Engineered: solid timber top layer on multi-layer cross plywood base |
| Core | Multi-layer cross plywood |
| Top layer | 3mm |
| Grade | Prime |
Surface
| Finish | Matt UV lacquer, gloss 5-8% |
|---|---|
| Surface | Brushed |
| Edge | 4-sided micro bevel |
Installation
| Profile / locking | Tongue and groove |
|---|---|
| Installation methods | direct-stick |
Performance
| Slip rating | P3 |
|---|---|
| Emissions | Formaldehyde release 0.16 mg/L (AS/NZS 2098.11-2005 desiccator method, AWTA, Feb 2025) |
Warranty
| Residential | 20 years wear, residential |
|---|---|
| Structural | Lifetime structural (subject to the warranty terms) |
Subject to the manufacturer’s installation and care conditions.
Documents
Like this floor? We’ll measure up and quote it properly.