European Oak 15mm Prime Herringbone Engineered Timber

15mm thick
3mm top layer
120mm wide
Matt UV lacquer, gloss 5-8%

Range specifications

Shared by every colour in this range, from the supplier’s brochure, installation guide and warranty.

Dimensions

Thickness	15mm
Width	120mm
Length	600mm
Pack size	1.152 m²
Boards per pack	16

Construction

Species	European Oak
Construction	Engineered: solid timber top layer on multi-layer cross plywood base
Core	Multi-layer cross plywood
Top layer	3mm
Grade	Prime

Surface

Finish	Matt UV lacquer, gloss 5-8%
Surface	Brushed
Edge	4-sided micro bevel

Installation

Profile / locking	Tongue and groove
Installation methods	direct-stick

Performance

Slip rating	P3
Emissions	Formaldehyde release 0.16 mg/L (AS/NZS 2098.11-2005 desiccator method, AWTA, Feb 2025)

Warranty

Residential	20 years wear, residential
Structural	Lifetime structural (subject to the warranty terms)

Subject to the manufacturer’s installation and care conditions.

This oak herringbone uses Prime-grade European oak, the cleanest of three grades, so the pattern reads clearly without busy knots. Each block is 600mm long, 120mm wide and 15mm thick, with a 3mm oak top layer on cross plywood, tongue-and-groove edges and a four-sided micro bevel. The brushed face carries a super-matt UV lacquer. There are 15 colours, from white-washed through natural to charred. Herringbone must be glued directly to the subfloor; it can’t float. Allow about 20% extra for cutting waste, and use an installer experienced in parquetry. It suits living rooms, entries and dining rooms. Keep it out of bathrooms, laundries and rooms with a floor drain. Hydronic underfloor heating is allowed with the floor kept at 26°C or below; electric heating isn’t. Refinishing voids the warranty. The warranty covers wear for 20 years in homes and the board structure for life, subject to the manufacturer’s installation and care conditions.

Will it suit your home?

Bathrooms & laundriesNot suitable
Not for bathrooms, toilets, laundries or any room with a floor drain; the warranty excludes them.
Underfloor heatingWith conditions
Hydronic heating only, with the floor surface never above 26°C; electric heating isn't suitable.
Sanding & refinishingVoids the warranty
Sanding or refinishing the factory finish voids the warranty, so look after the surface with felt pads and mats.
Pets & high trafficWith care
Brushed matt lacquer hides light marks, but damage from grit, dragged furniture, stilettos and dropped items isn't covered by warranty.
Apartments (acoustic)Rating not confirmed
No acoustic test results are published for this format, so check with us and your strata before choosing it for an apartment.